The following introduces the four characteristics of the glass on the glass door of the refrigerator

Installation method of display cabinet glass door:
1. Material requirements:
1. Cutting according to the layout drawing: In order to avoid glass processing scale errors caused by uneven glass joints, in addition to the blanking list of the attached drawings, it is also necessary to attach the layout drawing and number the specifications and specifications of each piece of glass. quantity. When processing in the factory, the entire wall should be cut according to the layout drawing, and large pieces of glass should be cut as much as possible to eliminate the dimensional deviation. The glass shall be marked and numbered according to the layout drawing.


2. When cutting glass, attention should be paid to the gap. If there is a requirement in the design, the width should be saved according to the design requirement. There is no need to leave a 2mm gap between the two pieces of glass in the design to avoid damage due to thermal expansion and cold contraction when the temperature changes.

3. Scale accuracy requirements: the geometrical scale error of glass processing shall not exceed 1 mm. The size of the glass should be checked before installation. If the error is too large, it should not be installed.

It should be reported to the construction supervisor and materials personnel for return and replacement. The glass with grinding edges should also be checked to see whether the edges are uniform, straight, and whether the scale meets the requirements.
4. Color: Check the color of the colored glass before installation to see if it is consistent.

If there is a color difference, it should be reported to the construction supervisor and material personnel, and it should be returned and replaced in serious cases.
Second, the basic treatment:
1. In order to prevent the base wood plywood from deforming due to moisture, the paint on the back of the glass and the mercury on the back of the mirror will fall off due to moisture. The surface of the plywood wall of the basic plank should use moisture-proof paint, and the wood planks wedged into the wall should be immersed in the waterproof paint.

The toilet mirror wall should also be waterproof and moisture-proof.
2. The base wooden plywood device is strong, and the flatness and verticality should meet the specification requirements to ensure that the glass device is strong and stable.