Understand, the high-tech refrigerator glass door of the thermostatic wine cooler

Freezer glass doors are mainly used in shopping malls, supermarkets and other consumer places. In such a place with a lot of traffic, how should the freezer glass door be maintained? Let you know.

1. How to use the glass door of the freezer:

First of all, the refrigerator should pay attention to whether the location is reasonable and whether it is easy to dissipate heat.

And you also need to check the power supply of the house, whether it is grounded, and whether it is a dedicated line.

2. Before using, the user should carefully read the attached product manual and check each part. The common power supply is 220V, 50Hz single-phase AC power supply.

In normal operation, voltage fluctuations are allowed between 187-242v. If the fluctuation is large, high or low, it will affect the normal operation of the compressor, or even burn the compressor.

3. The glass door of the freezer should use a single-phase three-hole socket and separate the wiring.

Pay attention to protecting the insulation layer of the power cord, do not press the wire hard, and do not replace or lengthen the power cord at will.

4. After the inspection is correct, it should be left to stand for 2 to 6 hours before starting to avoid oil circuit failure (after treatment). After connecting the power supply, listen carefully to whether the sound of the compressor is normal during startup and operation, and whether there is a sound of pipes colliding with each other.

If the noise is too loud, please check whether the noise is stable and whether the pipes are in contact, and make corresponding adjustments. If there is a loud abnormal sound, please cut off the power immediately and contact professional maintenance personnel.

5. Since the new moving parts are in operation, the load should be reduced so that it can run at the beginning of use.

After running for a period of time, it will increase more, which can extend the service life.

6. There should not be too much food stored, and proper space should be reserved to keep the air conditioner circulating and prevent long-term and full-load operation. Before putting hot food in, it should be cooled to room temperature first, and avoid running the refrigerator for a long time.

The food should be sealed with a fresh-keeping bag or paper, or put in a sealed container to prevent the food from getting damp, falling water and threading. After removing the water, the food with water should be put into the water to avoid excessive frost due to the transpiration of a large amount of water. Note: Do not put liquids or glassware in the freezer to avoid breakage.

Do not place volatile, flammable chemicals and corrosive acid and alkali items to avoid damage.

How to maintain the glass door of the freezer:

The glass door of the freezer is the eyes of the convenience store. It is as bright as the new glass door of the freezer. It will always make people look happy. So how to maintain the glass door of the freezer? Here are some tips for you. Good maintenance can not only make the glass door of the freezer as bright as new, but also prolong the service life of the glass door of the freezer.

In order to ensure the cleanliness and brightness of the refrigerator, we often scrub the glass of the refrigerator. When scrubbing, care should be taken not to use strong acid and alkali cleaning products (such as decontamination powder), and do not use ordinary soap to wash powder. Cleaning is very good with a soft cloth dampened with water, but the cleaning effect is not satisfactory.

I was able to add some neutral detergent.

In addition to external cleaning, attention should also be paid to internal cleaning. The main purpose of internal cleaning is to clean the slides and the sand and dust in the groove where the glass door of the freezer is connected to the fan, which will have an adverse effect on the use of the glass door and hardware of the push-pull freezer.

Generally, it can be cleaned every three months. It can be cleaned with a vacuum cleaner and a soft cloth. Check the floor spring, wind brace and positioning shaft pin every six months, and add lubricating oil in time to maintain the elasticity of the switch.

Keep an eye out for water or frost in the inner grooves. If there is water, please clean it in time. When cleaning the glass door of the freezer, please pay attention to safety to avoid accidents.

Especially when using refrigerators in large shopping malls, you must pay attention to safety when cleaning the refrigerators. Don't worry if there is rust in the refrigerator due to oxidation. Just gently scrape off the rust with a knife, wash the rust with soapy water, dry it with a dry soft cloth, apply wax oil, and scrub it with a dry cloth to make it lubricious as new.

Because the condenser and compressor of the refrigerator are outside, it is easy to accumulate dust and cobwebs during use. In daily life, people often don't pay attention to it. What should we do now? The most important way is to use a soft brush to clean it.

Do not rinse with water. It will reduce its insulation performance, which is not conducive to extending the service life. If you want to clean the inner walls of the refrigerator, you should remove all pre-stored items and parts, and then perform a thorough cleaning.

You will also need to clean the door seals. You can apply an appropriate amount of talcum powder to prevent the seal from sticking.

If most friends still have peculiar smell after cleaning the glass door of the freezer, you can use sodium bicarbonate with a concentration of no more than 3% to carefully clean the inner wall of the glass door of the freezer again to remove the peculiar smell very quickly.

time. However, forcibly cutting off the power supply will generally cause the motor to burn out. A good way is to stop the refrigerator and wait.

When the temperature drops to a certain value, please cut off the power supply, and then pull out the power plug.